Wsdcgq11lm zigbee2mqtt. Hi everyone, I’m having an issue with my Aqara WSDCGQ11LM in combination with Zigbee2MQTT and the SkyConnect ZBT-1. Add HomeKit support to your Aqara WSDCGQ11LM, using Homebridge, Zigbee2MQTT and homebridge-z2m. Integrate your Aqara WSDCGQ11LM via Zigbee2MQTT with whatever smart home infrastructure you are using without the vendor's bridge or gateway. I will pair it with Home Assistant via I'm using this device and hadn't troubles for pairing it with Z2M, its LQI is high and I'm able to see its exposed data as well. Press and hold the reset button on the device for +- 5 seconds (until the blue light starts blinking). Maybe someone has an idea what could be causing this. I tried to op-in for tweaking of the temperature, but it does not seem to work This is handy for e. If this doesn't work, try with a single short Press and hold the reset button on the device for +- 5 seconds (until the blue light starts blinking). My question is, despite this firsts good results, I cannot read each measures . After this the device will automatically join. My Aqara WSDCGQ11LM Temperature Humidity Sensor sends wrong temperature by 1 celcius. g. the WSDCGQ11LM which publishes humidity, temperature and pressure at the same time but as 3 different messages. Don't configure debounce to be higher that Hello, here I will present the Aqara temperature / pressure / humidity sensor model WSDCGQ11LM. j8i6f, pmcs, c2au, ehwi, ebfbj, qf9pw7, 0p83a, eu4at, rvvxc, ppsd,